Los siguientes drivers que soportan el modem SpeedStream 3060-3061 para Linux, no han sido certificados por nosotros mismos aún, pero todo parece indicar que soportan el protocolo CIP (Classical IP) RFC-1577 que es el utilizado por terra. Además soportan el RFC-1483, y PPPoA y PPPoE.
Para utilizar estos drivers es necesario recompilar el kernel con una versión que propiamente se indica en la siguiente dirección, teniendo en cuenta que el download de este kernel está entorno a los 95 Megas.
Podeis descargar todo de esta dirección.
Podeis seguir leyendo este artículo para ver las especificaciones cubiertas por este driver.
ENI 3061 Functional Capabilities
Plug-and-Play installation
WAN Interfaces:
ALCATEL DynaMiTe Chipset
ANSI T1.413 Issue 2
ITU G.992.1 (G.dmt)
ITU G.992.2 (G.Lite) (available 8/00)
Connector
RJ-11, pins 3 & 4
PCI Interfaces:
Single-slot PCI Bus adapter
32 bit, 33Mhz PCI bus (upward to 100Mhz)
Bus Master capability
Memory: 16MB, 32-bit non-prefetchable
Power Management 2
Medium Device Selector
Latency: 80
Visual Indicators
LED (green) indicates network status
Protocol Support (supplied by Linux Community)
ATM Protocols:
UNI 4.0, 3.1, 3.0 (ATM Forum)
ATM Multiprotocol Encapsulation
over ATM Adaptation Layer 5
(RFC 1483, RFC 2864) Logical Link
Control (LLC) and Virtual MUX
encapsulation PVCs.
RFC1483 Routed IP over ATM PVCs and SVCs
RFC1577 Classical IP over ATM PVCs and SVCs
PPP over ATM and PPP over Ethernet:
PAP, CHAP or no authentication (RFC 2364)
PVCs only.
ATM Traffic Shaping:
Unspecified Bit Rate (UBR)
Variable Bit Rate (VBR)
See Linux-ATM forum on limit of VPI/VCI. Currently supported as:
VPI 0-1023
VCI 32-65535
Hardware Specification:
Environmental Requirements:
Operating Temperature: 0-70 degree Celsius
Power Requirements:
0.75A max @ +5V +/- 0.1A
Max @ +/-12V +/- 5%
Dimensions:
TBS
Weight:
TBS
Agency Approvals:
U/L 1950 CSA
EN60950
FCC Part 15 Class B
CISPR Class B
FCC Part 68

Anónimo
Pues yo llevo un rato intentando hacerlos funcionar y no hay forma… El problema es que el driver en sí viene en binario, en un módulo, y no hay modo de inveestigar el código a ver que es lo que falla… Quizá sea cuestión de IRQ o algo así, os intentaré mantener informados si lo consigo
PD: Ocupa 80 Mb porque está incluido el tar de un kernel parcheado SIN COMPRIMIR.
Anónimo
Pues nada si lo consigues y preparas un kit con todo sería genial.
Ánimo desde ADSLNet
Anónimo
Son para NetBSD
Anónimo
Hola:
Pues nada, simplemente deciros que el link no rula y que no tengo drivers pa linux pa mi que funcionen, de forma que si alguno es tan amable de facilitarme alguno que rule, pos se lo agradeceré.